The IQ-275-Alert Programmable Dimmer adds the capability to initiate a brief flashing sequence to the IQ-275 features.
This allows you to program the low beam setting on your auxiliary lights anywhere from off to 100% in 10% increments. Lights automatically go to high beam when the vehicles high beam is activated. No added switches are required! After all, adding a rheostat dial on your bars is like going back to the stone age!
unique ALERT! feature on the IQ-275-A enables you to initiate a brief,
highly conspicuous flashing sequence when you really need to be noticed
by traffic ahead.
Just tap your high beam switch twice within one
second, and the controller rapidly modulates the brightness of the lamps
attached to the controller. No matter what brightness you have the
lamps set to, even if they're off, they will immediately flash at
maximum brightness in a very conspicuous sequence. The sequence takes
less than two seconds, but will greatly improve your likelihood of being
Normal application of the high beam or a single tap will
not trigger the ALERT! sequence, so it has no effect on your usual
Note: If you have a bike with a factory LED headlight we advise you to get the IQ-275X witch has provisions for inverted headlight signal that comes on some of the bikes with factory LED headlights AKA. T700, 1290 Adv
Skene IQ-275X-IQ-275X (skenelights.com)
WHAT IS INCLUDED?
IQ-275-A controller - 1
Adhesive velcro squares - 2
Posi-Tap® connectors - 3
Posi-Twist® connector - 4
Installation manual - 1