Includes our redesigned and enhanced LED modules!
The improved LEDs offer a modern look, rugged aluminum housing, and
wider beam angle with the same brightness, size, and mounting as our
previous LEDs.
The P3 Lights-TS model includes turn signal
capability that flashes the left and right LEDs in sync with the bike's
turn signals in addition to all of the tail light, brake light and
emergency flashers capability of the base P3 model.
The system includes an intelligent control module, two new enhanced red Photon Booster LED modules, universal mounting brackets, wire connectors and instructions.
The
P3 rear visibility lighting system optimizes your bike's visibility by
adding two rows of very bright, computer-controlled LEDs to your
motorcycle's rear license plate, supplementing your bike's existing tail
light, brake light and emergency flashers. Compatible with all
motorcycle brands, the system includes an intelligent control module,
two red Photon Booster LED modules, universal mounting brackets, wire
connectors and instructions.
WHAT IS INCLUDED?
IQ-260-TS controller - 1
NEW enhanced Red LED module w/universal mounting bracket - 2
Adhesive velcro squares - 2
Posi-Tap connectors - 5
Posi-Twist connector - 2
6mm bolt & lock nut - 2
Installation manual - 1
Programming card - 2
TECH SPECS
- Current draw: tail light 100 mA; brake light 390 mA instantaneous, 150 mA continuous
- Operating voltage: 9 - 16 VDC
- Maximum allowed current: 3 amps for P3, 6 amps (3 per side left & right) for P3-TS (equivalent to 40 of our LED modules)
- Intensity regulation: LED intensity is controlled by an internal current regulator to maintain brightness even under low voltage conditions.
- Beam pattern: oval 20° x 70°
- Wavelength: 624 nm
- Control module dimensions: Length: 1.75" Width: 1.31" Height: 0.5"
- Control module weight: 1 oz.
- LED module dimensions: 3" x 13/16" x 7/16"
- LED module weight: 1.8 oz.
- Fully compatible with BMW CAN-bus
- Fully compatible
with BMW 2-phase brake light firmware that illuminates a single-filament
brake light as a tail light, as used on the R1200RT and other models.
Go To Install Page