Proudly Made in the USA
The BMW R1100GS is a simple, straightforward installation.
- Remove the rear tail light lens using a Phillips screw driver.
- Remove the tail light assembly by removing the two Phillips screws inset into the reflector.
- Note the position of the 3 wires connected to the bulb socket, and remove these wires.
- Then attach each of the three gray/red Posi-Tap® connectors onto the Brown (ground), Gray/Red (tail light), and Gray/Black (brake light) wires.
- Connect the controller wires as follows:
- Controller's black wire to the tap on the Brown wire
- Controller's red wire to the tap on the Gray/Red wire
- Controller's white wire to the tap on the Gray/Black wire
- Install the LED modules on either side of the license plate as shown using the included license plate mounting hardware..
- Run the wires up through the slot molded into the tail assembly.
- Cut the wires from the LED modules to the correct length and connect the copper wires to the ground and the silver wires to the controller's gray/green wire as described in the standard installation instructions
- Bend the aluminum LED module brackets so that the LEDs are pointing straight back to provide maximum visibility
